Learn How to Do iPhone X Screen Replacement in Easy Steps

Is your iPhone screen cracked? If so, then follow this guide to restore your iPhone X to working order with a new screen. So without wasting any more time, let us get into how to iPhone X TFT replacement can be commenced.

Step 1

Opening Procedure

• The first step should be to contain the breakage by taping over the glass.
• The next thing is to put suction cups attached as this a handy tool. Just position the suction cups near the bottom edge of the iPhone and press firmly. Hold onto the phone securely and close the handle to slightly separate the screen from the rear case of the phone. Now gently pull up the screen.

Step 2

• The next step is to slide the opening pick around the lower-left corner and up the left edge of the iPhone. Re-insert your pick at the bottom edge of the iPhone, and slide it up the right side.
• Pull-on the small nub on the suction cup to remove it from the front panel.

Step 3

• Open the iPhone by swinging the display up, but don't try to fully separate it, because there are various fragile cables still connected.
• Lean the display against something to keep it in a suitable condition while you're working on the phone

Step 4

• Remove five Y000 screws securing the logic board connector bracket. Now remove the bracket.
• Now pry the battery connector up from its socket on the logic board
• The next thing is to use the point of a spudger or a fingernail to disconnect the OLED panel cable connector.
• Now utilize the spudger point in order to pry the iPhone 5c screen and digitizer connector from the socket.

Step 5

Earpiece Speaker and Front Sensor Assembly

• After removing the assembly, remove the 1.2 mm Y000 screw on the back of the display assembly.
• Now you will find a little grounding clip remove it now. Now remove two more Y000 screws securing the speaker or sensor assembly.
• Now pry under the top edge of the speaker assembly, and flip it over. Carefully slide the flat edge of your spudger underneath the flex cable.
• Separate the microphone by using the point of the spudger.
• Gently wiggle and lift to separate the module from its notch in the front panel.

Step 6

• After removing the ambient light sensor, then you will see that a white diffuser strip detached and remains embedded in the display.
• You will need to carefully lever it out along the top edge using a pry tool
• Remove the earpiece speaker and front sensor assembly.

If you want an iPhone 6 screen replacement kit UK, then get it from a best online store, PartFect. Just get your replacement kit from them which they are offering at the most affordable pricing.